A Step by Step Guide To Sanding Floors

Sanding floor refers to removing the top layer of a wooden floor through gritting or other abrasive material. Wooden floors just like any other type of floor, gets dull and loose its polish over time mostly because of stains. It is important to sand floors over regular periods of time if you want to keep the wooden floors in top condition for a long time. There are multiple refurbishment companies that provide special services for sanding as well as sanding floor in Laval. You can employ the services of such companies for sanding floors in your house and office. However, the actual process of sanding floors is quite easy and a lot of people prefer to do it themselves. This article describes the step by step guide for sanding floors.

Prepare the Room

First of all, you need to prepare the room for sanding. Start by taking all the furniture out of room. It is important to completely empty the room for a perfect job. You should also take out the base shoe at the bottom of the baseboards to completely sand the floor. This may see insignificant but it can leave a prominent area of the floor uncovered and is noticeable after the job is done. Also, take apart the doors from the frame to make it easier to reach below them while sanding floors.

Rent the Equipment

Since sanding floors is an annual process, you do no need to buy the heavy and expensive sanding equipment. Fortunately, there are companies that rent out the equipment for a few days. You will need two sanding machines, one is the big drum sander that sands most of the floor but it cannot reach the corners. Second machine is a small edger that sands the corners of the floor. Always make sure to rent the equipment after you have prepared the room in order to lower the cost of rent.

Sweep the Room and Check the Floorboards

It is necessary to remove any kind of loose dirt and debris from the wooden floor before sanding it. Check the conditions of the floorboards, whether they need extra care or not. If the wooden floorboards have gaps in them due to weather conditions, you should fix it before sanding the floor. The same goes for other floor issues. The wooden floor should be in a stable condition for proper sanding.

Sand Diagonally

The best patterns to sand the floor is diagonal. Once you start the drum sander, do not stop after a few seconds, keep going in one motion otherwise it will leave patterns and smudges on the wooden floor. Run the machines for a few times diagonally on the floor, after which do some length wise motions as well. You will see the results immediately. If you are satisfied with the results, use the edger to sand the edges of the wooden floor. This will require more concentration and effort. Also, do not forget to change the gritting cheat belt frequent for a good job. Finish off the sanding by varnishing the floor with oils or satin varnish to protect the floors from future damages.


About


Full Home Improvement by Xohaib